SIwave in 2 Minutes: Modify a Plane Geometry

Introduction

This guide will walk you through the process of modifying a plane in SI Wave. Follow these steps to make adjustments to your plane geometry efficiently.

Steps to Modify a Plane

1. Select the Plane: Begin by selecting the plane you wish to modify.
2. Access Properties: Navigate to the properties under the boundary section and click on Edit.
3. Modify Vertices:
   • You will see all the vertices that construct the plane.
   • You can modify existing vertices or add new ones above or below any of them.
4. Convert Sections to Arcs:
   • You can convert any section or side into an arc.
   • Specify the center of the arc in the X and Y coordinates.
   • SI Wave will create a radius from this point to the specified point, forming an arc.
5. Set Arc Radius:
   • For example, if you set the radius of the plane to a specific point, such as 10 or 15, the arc will start from this point and extend towards the specified endpoint.
6. Finalize Modifications:
   • Click OK to apply the changes.
   • If the arc does not fit with the other vertices, SI Wave will add an additional side.

Conclusion

Ensure you perform the necessary calculations to determine the correct location of the center of the plane for accurate modifications. Thank you for following this guide.

Note: This guide is provided by Ozen Engineering, Inc.